TECHNICAL DRAWING (SS 2) MIDTERM ASSIGNMENT

Oluwadimu O.M

 TECHNICAL DRAWING (SS 2)  MIDTERM ASSIGNMENT

(On an A3 size drawing paper answer the following question)


1. Using appropriate Principles of Tangency as taught in SS1 construct the figure as shown                 below. 
    (Note: Where it is written R55 use R25)

2. Construct two circles of R30 and divide them into 8 and 12 equal parts respectively. 

3. Watch the video below and answer the question that follows.


Use the given dimensions at the beginning of the video to construct. entirely, what you have watched.
(For Procedures on the above check Pages 121 and 122 of New Basic Technical construction methods by Yode Owolade and Pages 104-105 of Technical drawing for school cert and G.C.E by J.N Green)



Comments

Post a Comment

Thanks very much we will get back to you

Popular posts from this blog

BUILDING DRAWING (NEW)

Oluwadimu O.M
Image
  BUILDING DRAWING ASSIGNMENT The sketch below shows the floor plan of a twin three-bedroom bungalow in the line diagram. Study the given specifications and answer the questions that follow: FOUNDATION:          675 x 225 concrete strip foundation at a depth of 800 from ground level. FLOOR:                       200 hardcore; 150 thick concrete floor; 25 cement sand screed. WALL:                          All walls are 225 hollow sandcrete blocks with 12 renderings on both sides. LINTEL:                       225 x 225 reinforced concrete. DOOR:                          All doors are flush wooden. D – 2100 x 900 x 38 in 100 x 50 timber frame. WINDOWS:                  All windows are sliding-glazed sash in aluminium frames.                                                   W1 – 800 x 500;                                                                                    W2 – 1200 x 1100. ROOF: 30 double pitch with 13 corrugated asbestos sheet;                   Rafter – 100 x 50 at 1200
Read more

TECHNICAL DRAWING (SS 1) MIDTERM ASSIGNMENT

Oluwadimu O.M
 TECHNICAL DRAWING (SS 1)  MIDTERM ASSIGNMENT (On an A3 size drawing sheet answer the following questions) 1.  Construct an inclined line of any convenient angle of length 125mm and divide into 10 equal parts. 2. Construct a line AB of length 85mm and bisect at point C. 3. Construct parallel lines of 50mm length with equal distance of 30mm. 4. Construct a triangle XYZ of length XY=YZ=XZ = 60mm. Use XY as the base. What is the name of the triangle you have constructed. 5. Construct a triangle ABC of  lengths AB as the base =75mm, BC= 65mm and AC=65mm.      Measure angles ABC and CAB. What type of  triangle is ABC.
Read more